Furnace Repair
Warm home or your money back — same-day furnace service across Stark County.
About this service
Furnace failures in Ohio winters are not an inconvenience — they are an emergency. Foster's Heating & Air provides same-day furnace repair across Stark, Summit, and Portage Counties for gas furnaces, electric furnaces, and heat pumps. Our technicians handle ignition failures, blower motor problems, limit switch faults, heat exchangers, gas valve issues, and thermostat malfunctions. We arrive with the diagnostic tools to identify the problem fast and the parts to fix it in one visit.
Process
How it works
Here is what happens when you schedule furnace repair with Foster's.
Call the shop by 2 PM Monday through Friday and we schedule same-day service across Stark, Summit, and Portage Counties.
Technician diagnoses the heating system using digital manometer, combustion analyzer, and multimeter — not guesswork.
Failed components are shown to the homeowner, explained in plain terms, and priced in writing before work begins.
We run the furnace through a full heating cycle and check temperature rise, gas pressure, and flame quality before leaving.
Signs you need this service
- No heat from the vents when the thermostat is calling for heating
- Furnace ignitor glows but the burner does not light — delayed ignition or a failed flame sensor
- Blower runs continuously and will not shut off even after the house reaches temperature
- Yellow or flickering orange flame instead of a steady blue flame — indicates incomplete combustion
- Sulfur or rotten egg smell near the furnace — turn off the gas and call immediately
- Furnace making loud booming sounds when the burner ignites — could indicate a delayed ignition
- Circuit breaker trips repeatedly when the furnace runs — could indicate a short in the control board or motor
Common causes
- Failed hot surface ignitor — most common failure on modern gas furnaces after 8–12 years of use
- Dirty flame sensor rod — causes the furnace to shut off after a few minutes of operation
- Clogged filter causing the furnace to overheat and trip the limit switch repeatedly
- Faulty pressure switch or sail switch preventing the inducer motor from powering up
- Failed blower motor or blower capacitor — common in older furnaces or after power surges
- Cracked heat exchanger — dangerous carbon monoxide leak risk; requires professional inspection
What to expect
Working with Foster's Heating & Air
Our technician arrives in a marked van and works through a systematic diagnosis using combustion analysis and electrical testing. We identify the exact failed component, show you the problem, and provide a written repair price. We do not upsell — if a repair makes sense we recommend it; if replacement is the better long-term choice we tell you that too.
Coverage
Service area
Furnace repair service for homeowners in Canton, North Canton, Akron, Massillon, Louisville, Alliance, Ravenna, Stow, Barberton, Streetsboro, and all surrounding Stark, Summit, and Portage County communities.
Questions
Furnace Repair FAQs
How much does furnace repair cost in Ohio?
Furnace repair in the Canton and Akron area ranges from $130 to $550 depending on the issue. Ignitor replacement, flame sensor cleaning, and capacitor replacement are in the lower range. Blower motor replacement, gas valve replacement, or heat exchanger work costs more. We provide upfront pricing before work begins.
Should I replace my furnace or repair it?
If your furnace is less than 12 years old and the repair cost is under $1,000, a repair is usually the right call. If your furnace is over 15 years old, has had multiple repairs in the past two years, or the repair cost exceeds 50% of replacement cost, replacement often makes more long-term sense. We give you an honest recommendation — we do not sell you a new furnace when a repair is the better option.
What causes a furnace to not ignite?
Most ignition failures in modern gas furnaces are caused by a failed hot surface ignitor. When the ignitor fails, it cannot heat up enough to light the gas burner. Other causes include a faulty flame sensor, a problem with the gas valve, or an issue with the control board. Our technician uses diagnostic tools to identify the exact cause before recommending repair.
Is it dangerous to run a furnace with a cracked heat exchanger?
Yes. A cracked heat exchanger can leak carbon monoxide into your home — an invisible, odorless gas that is lethal in enclosed spaces. If our technician finds a cracked heat exchanger, we will not restart your furnace. We will explain the replacement options and help you make a safe decision.
Do you service heat pumps?
Yes. Heat pumps are increasingly common in Ohio homes as they provide both heating and cooling. We service and repair heat pump systems including reversing valve issues, defrost cycle problems, refrigerant charging, and compressor failures.
Related services
Other services we offer
Air Conditioning Repair
Fast relief when your A/C goes out — diagnosis and repair same day.
installationHVAC Installation
Correct equipment sizing and professional installation — not just the lowest price.
maintenanceAC Maintenance
Annual AC tune-ups prevent emergency breakdowns — $99 spring special.
Ready to schedule furnace repair?
Call the Louisville shop or request an estimate online — same-day service available across Stark, Summit, and Portage Counties.